Problem with alarm 2 output on atr 144
Posted: 10/08/2021, 11:14
Hello,
I did not find a related topic on this subject. I am using an atr 144 controller on a simple heating application. Everything works OK, the only problem is the output of alarm 2. It is connected on PIN 6 and 7. When the Proccess value goes over 50 I would like to turn on alarm 2, so I get 24 V on PIN 6.
What parameters should I set so I can achine the desired result.
Thank you for your answer in advance.
I did not find a related topic on this subject. I am using an atr 144 controller on a simple heating application. Everything works OK, the only problem is the output of alarm 2. It is connected on PIN 6 and 7. When the Proccess value goes over 50 I would like to turn on alarm 2, so I get 24 V on PIN 6.
What parameters should I set so I can achine the desired result.
Thank you for your answer in advance.