Page 1 of 1

[2000.35.016] Configuration and calibration not working

Posted: 31/05/2017, 9:20
by user15302
I hava a three wire PT100 conneted to 2000.35.016 and further to Moxa ioLogik R1240. ioLogic is configured to detect current signals (4-20 mA).

I configured 2000.35.016 to used 3 wire PT100, it was configured to use 4 wire by default. This configuration works. I am using android app.

2000.35.016 seems now to be connected correctly since I am able to detect current changes in ioLogic -device when PT100 is put in boiling water etc.

Now the problems. I am trying to set the ranges. I am able to save new ranges but it does not seem to have any effect on output.
Shouldn't it have an effect?

What is the default temperature range?

I set gain calibration but it either did not have an effect on output values.

I cannot set the data logger on? Is the feature unsupported in this device?

Re: [2000.35.016] Configuration and calibration not working

Posted: 31/05/2017, 17:28
by Pixsys tecnico 6
Hi,
the range have effect on output. Default value is -200 to 600°C (using PT100 probe), but you can change it. What your electrical connection and how is the power supply signal of the converter (2000.35.016)?



Best regards.

Re: [2000.35.016] Configuration and calibration not working

Posted: 13/06/2017, 13:47
by user15302
Thanks for the answer. Now that I tried it again I was able to set the temperature range.

2000 35 016 Configuration and calibration not working

Posted: 17/03/2019, 15:02
by HenryChind
I Have a Microsoft SideWinder X8 Wireless Mouse...... Please I Need help with the configuration for CoD BOps. I want to know what is the Best Calibration for it 4000dpi....

Thanks....

Re: [2000.35.016] Configuration and calibration not working

Posted: 18/03/2019, 9:08
by Pixsys tecnico 6
Hi Henry,
please for the Microsoft issue contact it. Sorry, but this is not a Microsoft forum.

Best Regards.