I hava a three wire PT100 conneted to 2000.35.016 and further to Moxa ioLogik R1240. ioLogic is configured to detect current signals (4-20 mA).
I configured 2000.35.016 to used 3 wire PT100, it was configured to use 4 wire by default. This configuration works. I am using android app.
2000.35.016 seems now to be connected correctly since I am able to detect current changes in ioLogic -device when PT100 is put in boiling water etc.
Now the problems. I am trying to set the ranges. I am able to save new ranges but it does not seem to have any effect on output.
Shouldn't it have an effect?
What is the default temperature range?
I set gain calibration but it either did not have an effect on output values.
I cannot set the data logger on? Is the feature unsupported in this device?
[2000.35.016] Configuration and calibration not working
-
- Posts: 2
- Joined: 31/05/2017, 8:58
-
- Moderatore
- Posts: 1194
- Joined: 12/09/2016, 14:49
Re: [2000.35.016] Configuration and calibration not working
Hi,
the range have effect on output. Default value is -200 to 600°C (using PT100 probe), but you can change it. What your electrical connection and how is the power supply signal of the converter (2000.35.016)?
Best regards.
the range have effect on output. Default value is -200 to 600°C (using PT100 probe), but you can change it. What your electrical connection and how is the power supply signal of the converter (2000.35.016)?
Best regards.
-
- Posts: 2
- Joined: 31/05/2017, 8:58
Re: [2000.35.016] Configuration and calibration not working
Thanks for the answer. Now that I tried it again I was able to set the temperature range.
-
- Posts: 6
- Joined: 03/02/2019, 19:08
- Location: Sri Lanka
- Contact:
2000 35 016 Configuration and calibration not working
I Have a Microsoft SideWinder X8 Wireless Mouse...... Please I Need help with the configuration for CoD BOps. I want to know what is the Best Calibration for it 4000dpi....
Thanks....
Thanks....
-
- Moderatore
- Posts: 1194
- Joined: 12/09/2016, 14:49
Re: [2000.35.016] Configuration and calibration not working
Hi Henry,
please for the Microsoft issue contact it. Sorry, but this is not a Microsoft forum.
Best Regards.
please for the Microsoft issue contact it. Sorry, but this is not a Microsoft forum.
Best Regards.