[ATR-11] Temperature limit on Programming
Posted: 12/11/2013, 10:09
Hi,
I have recently acquired a Gas Pottery Kiln controlled by an ATR-11. I have been programming a new simple firing cycle, but when I came to imputing the final Temperature for the end of the cycle the ATR-11 would only allow to input a maximum temp of 1070 degrees when wanted to input 1100 degrees. How can I change and increase this preset Temperature limit?
Thank you.
Simon
I have recently acquired a Gas Pottery Kiln controlled by an ATR-11. I have been programming a new simple firing cycle, but when I came to imputing the final Temperature for the end of the cycle the ATR-11 would only allow to input a maximum temp of 1070 degrees when wanted to input 1100 degrees. How can I change and increase this preset Temperature limit?
Thank you.
Simon