Page 1 of 1
Re: How to select the assign the Input or Output in TD 240
Posted: 17/12/2012, 16:30
by Pixsys tecnico 3
Dear Sir,
You do not need to set hardware as the inputs and outputs of the TD240-11AD.
When setting the outputs via code from 1 to 16 the outputs are activated automatically.
Conversely, if one reads the inputs from 1 to 16 inputs is automatically set.
Regards
Re: How to select the assign the Input or Output in TD 240
Posted: 05/02/2016, 9:13
by user10989
Pixsys tecnico 3 wrote:Dear Sir,
You do not need to set hardware as the inputs and outputs of the TD240-11AD.
When setting the outputs via code from 1 to 16 the outputs are activated automatically.
Conversely, if one reads the inputs from 1 to 16 inputs is automatically set.
Regards
Dear Sir,
I am using TD 240-11AD too. I connected push button on i-o connector m2 (pin 9) and LED light on pin 10. Program is very simple , I9 turn on Q10, but in debbug mode , coils arent active when i activate push button. My led light turn on, but i have 24 V on each pin on connector M2.
Please help, how to set inputs and outputs. One small example can help.
Thanks
Re: [TD24] How to select the assign the Input or Output
Posted: 05/02/2016, 9:46
by Pixsys tecnico 1
HJI,
do you have powered the expansion-board by PIN9-10 of M3?
A simple example is attached (Input I9 actives output Q10)
Cattura.JPG
Re: [TD24] How to select the assign the Input or Output
Posted: 05/02/2016, 10:37
by user10989
Pixsys tecnico 1 wrote:HJI,
do you have powered the expansion-board by PIN9-10 of M3?
A simple example is attached (Input I9 actives output Q10)
Cattura.JPG
Now i connect PIN9-10, and it works. Thank you very much for help. Just one more question. Can i connect 24 V on inputs 1-8?
Re: [TD24] How to select the assign the Input or Output
Posted: 05/02/2016, 11:05
by Pixsys tecnico 1
Hi,
to activate digital inputs you can use the voltage you applyed to PIN 9-10 of M3.