ATR621 Program issue after waiting time
Posted: 18/03/2021, 16:38
Hello.
I've been using ATR621 for several years now without any issue.
On the last process I made, the program didn't start after the initial waiting time. I've realized it only starts (C1 led on) after I temper SPu and push up button a bit.
That happens on both cY.01 and cY.02 but not on the last program I made, cY.03.
Could you tell me what's the issue and what is causing this?
Thanks a lot for the reply.
I've been using ATR621 for several years now without any issue.
On the last process I made, the program didn't start after the initial waiting time. I've realized it only starts (C1 led on) after I temper SPu and push up button a bit.
That happens on both cY.01 and cY.02 but not on the last program I made, cY.03.
Could you tell me what's the issue and what is causing this?
Thanks a lot for the reply.