Pixsys Forum

hello

i want to store the actual temperature via labview (5V). therefore i put the jumper on jp3. but then i only get 0.011 V altough the temperature is increasing.
any ideas?

Hi,
if you want to retransmit the input signal in volt 0-10V, you have to set the following parameters:

[Sen] set the type of sensor
[rEtr] "Pro.1"
[LoLr] and [uPLr] as the lower and the upper limits for analog output for example:
Temperature form 0°C to 100°C --> 0V to 10V, [LoLr]:"0" and [uPLr]: "100"

You have also to put the jumper on jp3.

thanks... works perfect!