Unable to activate Output1 in 4.20mA
Posted: 20/03/2019, 4:03
Dear mrs, mr,
I am using a ATR234-20ABC.
This device is connected with a drew point sensor 2 wire 4.20mA
I can see the value on the controller .
But I need to transert this value with the Controller Output C1 in 4.20mA
My configuration is
2 - Sen {4.20}
3 - dP {0.0}
4 - LoLS {-100}
5 - uPLS {20}
1 - cout {c4.20}
67 rEtr {MA P}
68 LoLr {0}
69 UPLr {100}
jumpers are on JP5 an JP7 JP9 0-- (as picture 5.1.j)
The controller is unable to activate the C1 output
Is it a controller s problem ? configuration problem ?
Best regards
renaud
I am using a ATR234-20ABC.
This device is connected with a drew point sensor 2 wire 4.20mA
I can see the value on the controller .
But I need to transert this value with the Controller Output C1 in 4.20mA
My configuration is
2 - Sen {4.20}
3 - dP {0.0}
4 - LoLS {-100}
5 - uPLS {20}
1 - cout {c4.20}
67 rEtr {MA P}
68 LoLr {0}
69 UPLr {100}
jumpers are on JP5 an JP7 JP9 0-- (as picture 5.1.j)
The controller is unable to activate the C1 output
Is it a controller s problem ? configuration problem ?
Best regards
renaud