Pixsys Forum

Hi, Im trying to connect a TD710 with a PL500 but it does not appear in the CANopen devices area or COMs devices area.
How can i connect them?

Hi,
had you install the last version of the LogicLab pixsys suite? You can donwload it by this link below.

http://reserved.pixsys.net/

Best regards.

Hi, I uninstall the software and install the pixsys suite that is on the download area and still can't see the PL500 on the CANopen and COM connections.
Here i attach the image:

https://ibb.co/jn5FBm

Hi,
this is correct. If you are using the TD410 target, you can't to add an PL500. The PL500 is another target. You can use the Modbus TCPIP protocoll to comunicate with another LogicLab project that uses PL500 target. If you are using Movicon you can use the Pixsys Driver directly to the Movicon station PL500.

Advise: follow this video tutorial.

http://forum.pixsys.net/viewtopic.php?f ... 5621#p5621

Best Regards.

Got it.

I have another question...
Can i connect an expansion module of PL500 like PLE500-6AD or PLE500-7AD by CANopen or modbus directly to a HMI or i have to use the PL500 PLC?

Hi,
the PL500 expansions "PLE500" can be use only for PL500 target. You can't use the PLE500 with other devices.
If you need I/O modules with HMI you can use the ETD1644-AD plug-in module:
http://www.pixsys.net/en/products/plcs- ... es/etd1644
or MCM260 modules:
http://www.pixsys.net/en/products/plcs- ... les/mcm260

Best regards.

Thank you