New ATR 902 not working
Posted: 21/02/2017, 22:12
Hello again,
I come from here:
http://forum.pixsys.net/viewtopic.php?f=27&t=1609
A broken ATR-901,
So I bought a brand new ATR-902, was supposed to be the substitute for the old ATR-901 malfunctioning.
And the new one is not working at all. I thought it should be as easy as plug-in it, but no, it does not work, it just never turn on the heating elements, but the controler is saying that they are on.
Relays are properly working, I've done again the wiring conexion to be sure that wasn't any contact problem, so far my kiln is been working with the ATR 901 but not with this new controller, and it's working with the new wiring/pin aswell.
Can you offer any type of explanation to that?
I come from here:
http://forum.pixsys.net/viewtopic.php?f=27&t=1609
A broken ATR-901,
So I bought a brand new ATR-902, was supposed to be the substitute for the old ATR-901 malfunctioning.
And the new one is not working at all. I thought it should be as easy as plug-in it, but no, it does not work, it just never turn on the heating elements, but the controler is saying that they are on.
Relays are properly working, I've done again the wiring conexion to be sure that wasn't any contact problem, so far my kiln is been working with the ATR 901 but not with this new controller, and it's working with the new wiring/pin aswell.
Can you offer any type of explanation to that?