Pixsys Forum

Yes,
before recompile, go to "projects/options", go to "code generation" tab and select flags:
-Run-time check of array bounds
-Run-time check of division by zero

Enable autorun only for LogicLab.

Run only LogicLab, compile and transfer. If there is some errors, you can see them on the screen (also with vnc).

Sorry by now I have a big problem.

I delete bin files from FTP (PlcCode0.bin and PlcCode1.bin).
I restarted IHM.

I launched LogicLab and connect to IHM (all is green with no code written so all is fine).
I downloaded code from logiclab to IHM everything was OK (SOURCE OK / CONNECTED in green).

So I did the same with Pagelab but I have a error at 15% : I try to download again and always the same error at the same pourcentage !

Hi,
when this appends, you have to delete via FTP both PLCcode.bin and reboot the HMI.

Yes it's what I did.

I tried at least 10 times this morning and the download stop at differents percentages (15%, 48%..) but failed each time !

It is really annoying and not very stable !

LogicLab is well connected (LEDs are in green).

I found a way to generate .bin with LogicLab but can't do the same thing for PageLab

If I do this I could send file directly via FTP. There is a way to do this ?

You can try to use this function
and then generate the code using the LogicLab opened.

Ok I tried what you said.

I was able to create the file PlcCode1.bin for PageLab.

I sent it via FTP everything was OK but before the end I have been disconnected and now I cannot connect to IHM !

Sorry but I think you have some communication problems. Normally there isn't problem during FTP transmission...