Pixsys ATR902-12ABC schematic request

weirdstuffgr · Post by **weirdstuffgr** » 11/06/2024, 13:12

Hi,
i'm a electronic repair shop here in Greece and i'm looking for a schematic/service manual of ATR902-12ABC.
One of my clients has a blown 8 pin chip on his device and looking for the part number in order to repair it.
Can i please have this information?
Thanks

miganpoll · Post by **miganpoll** » 03/07/2024, 9:29

Hi weirdstuffgr,tunnel rush
Have you checked if the manufacturer has an online repository for service manuals and schematics? Sometimes they offer downloadable PDFs on their website.

Post by **Pixsys tecnico 1** » 11/07/2024, 8:48

Hi,
do you need the connector/pin replacement for the "kiln side" or the ATR902 cable+connector?

The cable+connector cannot be supplied because it internally have some components that are used for the cold junction so it must be replaced in our factory during the calibrating of the entire unit (otherwise the temperature reading would be wrong).

weirdstuffgr · Post by **weirdstuffgr** » 11/07/2024, 10:34

Hi,
no i need the schematic for the controller PCB. I need to replace a blown chip on the board and i cannot view the part number because the part is destroyed. Thanks

Post by **Pixsys tecnico 1** » 11/07/2024, 11:43

Hi,
this is not possible.
To repair the controller you need to follow RMA procedure on our site and send the product to our factory.

weirdstuffgr · Post by **weirdstuffgr** » 11/07/2024, 12:07

thanks

Pixsys Forum