Hi,
i'm a electronic repair shop here in Greece and i'm looking for a schematic/service manual of ATR902-12ABC.
One of my clients has a blown 8 pin chip on his device and looking for the part number in order to repair it.
Can i please have this information?
Thanks
Pixsys ATR902-12ABC schematic request
-
- Posts: 2
- Joined: 03/07/2024, 9:18
Re: Pixsys ATR902-12ABC schematic request
Hi weirdstuffgr,tunnel rush
Have you checked if the manufacturer has an online repository for service manuals and schematics? Sometimes they offer downloadable PDFs on their website.
Have you checked if the manufacturer has an online repository for service manuals and schematics? Sometimes they offer downloadable PDFs on their website.
-
- Moderatore
- Posts: 1702
- Joined: 29/10/2010, 10:09
- Contact:
Re: Pixsys ATR902-12ABC schematic request
Hi,
do you need the connector/pin replacement for the "kiln side" or the ATR902 cable+connector?
The cable+connector cannot be supplied because it internally have some components that are used for the cold junction so it must be replaced in our factory during the calibrating of the entire unit (otherwise the temperature reading would be wrong).
do you need the connector/pin replacement for the "kiln side" or the ATR902 cable+connector?
The cable+connector cannot be supplied because it internally have some components that are used for the cold junction so it must be replaced in our factory during the calibrating of the entire unit (otherwise the temperature reading would be wrong).
-
- Posts: 3
- Joined: 11/06/2024, 13:06
Re: Pixsys ATR902-12ABC schematic request
Hi,
no i need the schematic for the controller PCB. I need to replace a blown chip on the board and i cannot view the part number because the part is destroyed. Thanks
no i need the schematic for the controller PCB. I need to replace a blown chip on the board and i cannot view the part number because the part is destroyed. Thanks
-
- Moderatore
- Posts: 1702
- Joined: 29/10/2010, 10:09
- Contact:
Re: Pixsys ATR902-12ABC schematic request
Hi,
this is not possible.
To repair the controller you need to follow RMA procedure on our site and send the product to our factory.
this is not possible.
To repair the controller you need to follow RMA procedure on our site and send the product to our factory.
-
- Posts: 3
- Joined: 11/06/2024, 13:06