Hello, good afternoon, I have a problem with a TCT500, when entering with the PL.Prog4.75 software and trying to communicate with the PLC the message that appears is "Device does not answer", I have verified that the cable is in good condition. status because I have tried it with another device and it works. I have also tried updating firmware as indicated in viewtopic.php?t=2483, but I cannot connect to the PLC, some other solution?
I also see in the software an "Upgrade Boot Version" option, can that function be useful?
PLC TCT500 Is not recognized
-
- Moderatore
- Posts: 1687
- Joined: 29/10/2010, 10:09
- Contact:
Re: PLC TCT500 Is not recognized
Hi,
are you using a native RS232 or an USB-RS232 converter? If you use a converter, please check in the converter driver settings to configure the transmit delay as as lower as possible.
are you using a native RS232 or an USB-RS232 converter? If you use a converter, please check in the converter driver settings to configure the transmit delay as as lower as possible.