Good morning,
After a power grid failure, the programmer does not activate the heating elements anymore.
It is as if the internal relays (of the programmer) do not engage.
I have checked the whole installation but I never get voltage on control output 6 & aux 7 when I should.
Is there any way to force (in test mode) the activation of these internal relays?
Thanks in advance.
Juan.
ATR 902 - Internal relays
Jump to
- Forum Italiano
- ↳ Argomenti Generali
- ↳ FAQ Regolatori e Termoregolatori
- ↳ FAQ Controllori di processo / Programmatori a step
- ↳ FAQ PLC, HMi e Interfacce
- ↳ HMI LogicLab - Movicon (TD410, TD710, TD810, TD820)
- ↳ PLC LogicLab (PL280, PL500, PL600)
- ↳ PLC e HMI Codesys (PL700, TC6xx, TC8xx)
- ↳ PanelPC (PC800, PC815, PC820, PC830)
- ↳ WebPanel (WPxxx)
- ↳ Moduli I/O e convertitori
- ↳ PLC e HMI PlProg - TdDesigner (EPL101, PL250, PL260, TD240, TD320)
- ↳ HMI LogicLab - PageLab (TDxxx, TY5xx, TY7xx)
- ↳ FAQ sonde e ssr
- ↳ FAQ Timer / Contatori / Tachimetri
- ↳ FAQ Inverter
- English Forum
- ↳ General Topics
- ↳ FAQ controllers
- ↳ FAQ Process controllers / Steps controllers
- ↳ FAQ PLC, HMI and Interfaces
- ↳ HMI LogicLab - Movicon (TD410, TD710, TD810, TD820)
- ↳ PLC LogicLab (PL280, PL500, PL600)
- ↳ PLC and HMI Codesys (PL700, TC6xx, TC8xx)
- ↳ PanelPC (PC800, PC815, PC820, PC830)
- ↳ WebPanel (WPxxx)
- ↳ I/O modules and converters
- ↳ PLC and HMI PlProg - TdDesigner (EPL101, PL250, PL260, TD240, TD320)
- ↳ HMI LogicLab - PageLab (TDxxx, TY5xx, TY7xx)
- ↳ FAQ sensors and SSR
- ↳ FAQ Timers / Counters / Tachometers
- ↳ FAQ Inverter