All, I am currently using a TD710 HMI, when I try to run my movicon program, I am getting an error via a pop up on screen:
"Cannot validate symbol table at startup, please check symbol table path and connection to the PLC then restart"
I believe the issue is with paths in the stations settings in comm drivers, and it not auto-populating or copying the file over.
Any ideas, as this is very frustrating.
movicon issue with symbol file on startup
-
- Moderatore
- Posts: 1196
- Joined: 12/09/2016, 14:49
Re: movicon issue with symbol file on startup
Good morning,
in the links below follow tutorial number 4 and 5 where it shows how to correctly configure the Movicon Station and how to correctly import PLC variables.
https://forum.pixsys.net/viewtopic.php?f=25&t=1768
Best Regards.
in the links below follow tutorial number 4 and 5 where it shows how to correctly configure the Movicon Station and how to correctly import PLC variables.
https://forum.pixsys.net/viewtopic.php?f=25&t=1768
Best Regards.
-
- Posts: 4
- Joined: 01/08/2019, 10:07
Re: movicon issue with symbol file on startup
Hi Pixsys tecnico 6, When I carry out the instructions in step 5, it does not copy the sym. xml file over to the HMI, even after I have uploaded the project. thoughts?
Thanks
Jamie
Thanks
Jamie
-
- Moderatore
- Posts: 1196
- Joined: 12/09/2016, 14:49
Re: movicon issue with symbol file on startup
Hi,
please check the LogicLab settings. Can you post the Movicon Station configuration?
Best Regards.
please check the LogicLab settings. Can you post the Movicon Station configuration?
Best Regards.
You do not have the required permissions to view the files attached to this post.
-
- Posts: 4
- Joined: 01/08/2019, 10:07
Re: movicon issue with symbol file on startup
You do not have the required permissions to view the files attached to this post.
-
- Moderatore
- Posts: 1196
- Joined: 12/09/2016, 14:49
Re: movicon issue with symbol file on startup
Hi,
please download an install the last version of the Movicon and PixsysSuite software at follow link:
1.https://cloud.pixsys.net/ 2.Instal the last driver available: 3. Close your Movicon Project and delete the follow files by your project RESOURCES folder. 4.Please check your Movicon Station settings. At follow picture there is a Typical settings: Best Regards.
please download an install the last version of the Movicon and PixsysSuite software at follow link:
1.https://cloud.pixsys.net/ 2.Instal the last driver available: 3. Close your Movicon Project and delete the follow files by your project RESOURCES folder. 4.Please check your Movicon Station settings. At follow picture there is a Typical settings: Best Regards.
You do not have the required permissions to view the files attached to this post.