This section shows some examples of design and parameterization of PDR Series inverters
Before downloading the examples, we recommend that you log in to http://www.pixsys.net and read the PDR user guide, accessible at the following link:
PDR100: https://www.pixsys.net/download_file.ph ... _REV.B.pdf
PDR200: https://www.pixsys.net/download_file.ph ... _REV.B.pdf
Example1: PDR100/PDR200 controlled by HMI TD810-AD
This application allows you to set and display the motor rpm frequency, the motor start/stop and direction of rotation, its acceleration and deceleration. The application development on HMI TD810-AD is implemented with Logiclab and Movicon11 software.
Bus: MODBUS RTU
Example PDR100 User Guide link:
Example PDR200 User Guide link:
Software Application link:
Example2: PDR100 controlled by ATR244-12ABC
This application allows to carry out a proportional band motor speed regulation according to the setpoint set and probe process reading. The output used is 0-10V of the ATR244-12ABC regulator. The application also allows to switch to a manual mode for the regulation of the 0-10V, omitting the parameters of the inserted proportional. The motor start/stop is defined by a digital input
Bus: MODBUS RTU
The parameter files of the ATR244-12ABC instrument are available at the following link:
The guide to the implementation of the project is available at the following link:
Example3: PDR100/PDR200 controlled by PLC Codesys 3.5 with supervisor TD710-AD
This application allows you to set and display the motor rpm frequency, the motor start/stop and direction of rotation, its acceleration and deceleration.
The development of the graphics is implemented on the TD710-AD with the software Movicon11.6, the development of the logic with the IDE Codesys 3.5.
Bus: MODBUS RTU
Example PDR100 User Guide link:
Example PDR200 User Guide link:
Software Application link:
[PDR100][PDR200]Project Example
-
- Moderatore
- Posts: 1201
- Joined: 12/09/2016, 14:49
[PDR100][PDR200]Project Example
You do not have the required permissions to view the files attached to this post.