ATR121 temperature up to 999 degrees

maismar · Post by **maismar** » 20/02/2019, 1:59

I programmed the parameters up to 999 degrees and when the temperature reaches 360 degrees back down to 0.
If anyone can help me, thank you

Post by **Pixsys tecnico 6** » 20/02/2019, 9:19

Hi,
what parameters has it changed compared to the default options? Please can you post a parameter list? Please, can you explain your application?

Best Regards.

maismar · Post by **maismar** » 21/02/2019, 17:17

c.ou o 1.2 t.c. 0
SEn tc.j AL. A.A
d.p. 0 c.r.A n.o.S
Lo.S 0 S.c.A. c.o.
HI.S 999 Ld2 c.c.
Lo.n 0 HY.A 0.0
HI.n. 999 dE.A 0
Lat Off P.SE. FrE
cA.o 0.0 FiL 10
cA.G 0.0 tun off
rEG. HEA Fnc d.SE
S.c.c. c.o. GrA ºC
Ld1 c.c. coF Air
HY.c 0.0 P.b.N 1.00
P.b. 0 aud 0
t.i. 0 t.c.2 10
t.d. 0 FL.u off

I'm using it to show the tempura of an oven with tempura up to 750 degrees.

maismar · Post by **maismar** » 21/02/2019, 17:27

I'm using it to show the tempura of an oven with tempura up to 750 degrees.

see the Attach

Post by **Pixsys tecnico 6** » 22/02/2019, 10:31

Hi,
we think there is a probe issue. What type of probe are you using? Are you sure it is a TC-J? If you are using a TC-J probe you don't need to change the default value of the parameters [Lo.n] and [Hi.n].

Best Regards

maismar · Post by **maismar** » 23/02/2019, 6:04

I think it is a probe type J 6x100 mm
At least that's what it says on the invoice
I'm calling posts 11 and 12

Best regard

Post by **Pixsys tecnico 6** » 25/02/2019, 10:16

Hi,
your electrical wire connections are right if you are using a Tc-j. Are you sure your tc-j is working fine? Did you try to use another tc-j?

Best regards.

Pixsys Forum