This application allows you to control the temperature and humidity using a PT100 signal on AI1 and a 0-10V signal on AI2 of the ATR401-24ABC controller. The regulation is in hot mode and is ON / OFF with 5 ° C of hysteresis on the temperature setpoint (relay Q1).
Alarm 1 is in absolute value and is activated above the set point with a hysteresis of 1 ° C for process 1 (temperature).
Alarm 2 is in absolute value and is activated above the setpoint with a hysteresis of 1% for process 2 (humidity).
The probe used is 2000.50.021. (Https://www.pixsys.net/it/prodotti/tras ... sm-umidita)
Electrical connections of the regulator towards the probe in question:
Signal AI1 (PT100)
PIN11 -> blue thread
PIN12 -> brown thread
PIN13 -> white thread
AI2 signal (0-10V)
PIN14 -> yellow / green thread
PIN15 -> black thread
PIN17 -> red thread
[ATR401] Temperature and humidity control Probe[2000.50.021]
-
- Posts: 1
- Joined: 14/08/2018, 11:54
-
- Moderatore
- Posts: 1188
- Joined: 12/09/2016, 14:49
Re: [ATR401] Temperature and humidity control Probe 2000.50.
Hi,
LabSoftview files and example print screen attached.
Best regards.
LabSoftview files and example print screen attached.
Best regards.
You do not have the required permissions to view the files attached to this post.