ATR901-12B controller won't turn on - ATR902 replacement?

[user16092]

Hi,

My wife has a bead kiln that was in storage for three years and having got it out recently the ATR901 controller is not turning on.

Unfortunatly the seller of the kiln and controller don't appear to be in business anymore (certainly not replying to emails or phone calls)

So far:

* When turning on the kiln a red light appears on the kiln, so power going through it
* The controller doesn't turn on or light up in any fashion
* The kiln does not heat up
* I have checked the fuse in the kiln, appears intact
* I have checked the fuse in the controller, appears intact
* There's no obvious damage on the controller circuit board that I can see - I know nothing about electronics though
* I have unplugged and reconnected the controller numerous times
* I have left the kiln turned on for a while but no evidence of heating up
* The temperature sensor in the kiln appears intact

In leui of any suggestions for the ATR901 and assuming it is dead, would the ATR902 be a direct bolt on replacement as in no soldering/facncy wiring to hook its lead up?

Thanks in advance

Glenn
Canberra, Australia

[Pixsys tecnico 6]

Hi,
you can to replace with a ATR902. Would the ATR902 be a direct bolt on replacement.

Best Regards.