[TD24] How to select the assign the Input or Output

Post by **Pixsys tecnico 3** » 17/12/2012, 16:30

Dear Sir,

You do not need to set hardware as the inputs and outputs of the TD240-11AD.

When setting the outputs via code from 1 to 16 the outputs are activated automatically.

Conversely, if one reads the inputs from 1 to 16 inputs is automatically set.

Regards

user10989 · Post by **user10989** » 05/02/2016, 9:13

Pixsys tecnico 3 wrote:Dear Sir,

You do not need to set hardware as the inputs and outputs of the TD240-11AD.

When setting the outputs via code from 1 to 16 the outputs are activated automatically.

Conversely, if one reads the inputs from 1 to 16 inputs is automatically set.

Regards

Dear Sir,

I am using TD 240-11AD too. I connected push button on i-o connector m2 (pin 9) and LED light on pin 10. Program is very simple , I9 turn on Q10, but in debbug mode , coils arent active when i activate push button. My led light turn on, but i have 24 V on each pin on connector M2.
Please help, how to set inputs and outputs. One small example can help.
Thanks

Post by **Pixsys tecnico 1** » 05/02/2016, 9:46

HJI,
do you have powered the expansion-board by PIN9-10 of M3?

A simple example is attached (Input I9 actives output Q10)

Cattura.JPG

user10989 · Post by **user10989** » 05/02/2016, 10:37

Pixsys tecnico 1 wrote:HJI,
do you have powered the expansion-board by PIN9-10 of M3?

A simple example is attached (Input I9 actives output Q10)
Cattura.JPG

Now i connect PIN9-10, and it works. Thank you very much for help. Just one more question. Can i connect 24 V on inputs 1-8?

Post by **Pixsys tecnico 1** » 05/02/2016, 11:05

Hi,
to activate digital inputs you can use the voltage you applyed to PIN 9-10 of M3.

Pixsys Forum