[TD700] remote reboot

[Pixsys tecnico 1]

Yes,
before recompile, go to "projects/options", go to "code generation" tab and select flags:
-Run-time check of array bounds
-Run-time check of division by zero

Enable autorun only for LogicLab.

Run only LogicLab, compile and transfer. If there is some errors, you can see them on the screen (also with vnc).

[user10683]

Sorry by now I have a big problem.

I delete bin files from FTP (PlcCode0.bin and PlcCode1.bin).
I restarted IHM.

I launched LogicLab and connect to IHM (all is green with no code written so all is fine).
I downloaded code from logiclab to IHM everything was OK (SOURCE OK / CONNECTED in green).

So I did the same with Pagelab but I have a error at 15% :

Code: Select all

Transferring is 15% failed.
error T8199:  Cannot download file C:\...\Cuverie MODBUS.cod => Code write failure

I try to download again and always the same error at the same pourcentage !

[Pixsys tecnico 1]

Hi,
when this appends, you have to delete via FTP both PLCcode.bin and reboot the HMI.

[user10683]

Yes it's what I did.

I tried at least 10 times this morning and the download stop at differents percentages (15%, 48%..) but failed each time !

It is really annoying and not very stable !

LogicLab is well connected (LEDs are in green).

I found a way to generate .bin with LogicLab but can't do the same thing for PageLab

If I do this I could send file directly via FTP. There is a way to do this ?

[Pixsys tecnico 1]

You can try to use this function

Cattura.JPG

and then generate the code using the LogicLab opened.

[user10683]

Ok I tried what you said.

I was able to create the file PlcCode1.bin for PageLab.

I sent it via FTP everything was OK but before the end I have been disconnected and now I cannot connect to IHM !

[Pixsys tecnico 1]

Sorry but I think you have some communication problems. Normally there isn't problem during FTP transmission...