[ATR-11] Temperature limit on Programming

user7071 · Post by **user7071** » 12/11/2013, 10:09

Hi,
I have recently acquired a Gas Pottery Kiln controlled by an ATR-11. I have been programming a new simple firing cycle, but when I came to imputing the final Temperature for the end of the cycle the ATR-11 would only allow to input a maximum temp of 1070 degrees when wanted to input 1100 degrees. How can I change and increase this preset Temperature limit?

Thank you.
Simon

Post by **Pixsys tecnico 1** » 12/11/2013, 10:14

Hi, you have to set P-07 to "1100"

user7071 · Post by **user7071** » 12/11/2013, 10:20

Hi
Is P7 in the configuration parameters?

user7071 · Post by **user7071** » 12/11/2013, 10:52

Hi
I,ve now reconfigured P-07 to 1100 OK, Good, Thanks.

But how do I reconfigured the ATR-170 That works along side my ATR-11

Regards

Simon

Post by **Pixsys tecnico 1** » 12/11/2013, 13:00

Parameter n.5 [Hi.1]

Pixsys Forum