Hi,
I have recently acquired a Gas Pottery Kiln controlled by an ATR-11. I have been programming a new simple firing cycle, but when I came to imputing the final Temperature for the end of the cycle the ATR-11 would only allow to input a maximum temp of 1070 degrees when wanted to input 1100 degrees. How can I change and increase this preset Temperature limit?
Thank you.
Simon
[ATR-11] Temperature limit on Programming
-
- Moderatore
- Posts: 1665
- Joined: 29/10/2010, 10:09
- Contact:
Re: The Temperature limit on Programming ATR-11
Hi, you have to set P-07 to "1100"
-
- Posts: 3
- Joined: 12/11/2013, 9:53
Re: The Temperature limit on Programming ATR-11
Hi
Is P7 in the configuration parameters?
Is P7 in the configuration parameters?
-
- Posts: 3
- Joined: 12/11/2013, 9:53
Re: The Temperature limit on Programming ATR-11
Hi
I,ve now reconfigured P-07 to 1100 OK, Good, Thanks.
But how do I reconfigured the ATR-170 That works along side my ATR-11
Regards
Simon
I,ve now reconfigured P-07 to 1100 OK, Good, Thanks.
But how do I reconfigured the ATR-170 That works along side my ATR-11
Regards
Simon
-
- Moderatore
- Posts: 1665
- Joined: 29/10/2010, 10:09
- Contact:
Re: The Temperature limit on Programming ATR-11
Parameter n.5 [Hi.1]