Iris _

Pixsys Forum

everybody's effort for the same goal

[ATR-11] Temperature limit on Programming

Post Reply
user7071
Posts: 3
Joined: 12/11/2013, 9:53

[ATR-11] Temperature limit on Programming

Post by user7071 »

Hi,
I have recently acquired a Gas Pottery Kiln controlled by an ATR-11. I have been programming a new simple firing cycle, but when I came to imputing the final Temperature for the end of the cycle the ATR-11 would only allow to input a maximum temp of 1070 degrees when wanted to input 1100 degrees. How can I change and increase this preset Temperature limit?

Thank you.
Simon
Pixsys tecnico 1
Moderatore
Posts: 1649
Joined: 29/10/2010, 10:09
Contact:

Re: The Temperature limit on Programming ATR-11

Post by Pixsys tecnico 1 »

Hi, you have to set P-07 to "1100"
user7071
Posts: 3
Joined: 12/11/2013, 9:53

Re: The Temperature limit on Programming ATR-11

Post by user7071 »

Hi
Is P7 in the configuration parameters?
user7071
Posts: 3
Joined: 12/11/2013, 9:53

Re: The Temperature limit on Programming ATR-11

Post by user7071 »

Hi
I,ve now reconfigured P-07 to 1100 OK, Good, Thanks.

But how do I reconfigured the ATR-170 That works along side my ATR-11

Regards

Simon
Pixsys tecnico 1
Moderatore
Posts: 1649
Joined: 29/10/2010, 10:09
Contact:

Re: The Temperature limit on Programming ATR-11

Post by Pixsys tecnico 1 »

Parameter n.5 [Hi.1]
Post Reply