Iris _

Pixsys Forum

everybody's effort for the same goal

[ATR620] Problem with powering-on programmer

Post Reply
user6743
Posts: 2
Joined: 26/09/2013, 22:43

[ATR620] Problem with powering-on programmer

Post by user6743 »

Dear sir,

I have a problem with ATR620 Process controller.
When is turn on, the name of the model (Atr620) is moving on the screen display. In the same time number 1.18 is blinked just like C1 C2 A1 A2 in the second line.
After that displayed shows number 14 and the word StoP.
None of all six keys (up, down, START STOP, PRGM, OK and six key) are not respond when I press any of them.

There is no such error problem information in the manual.
Is there any solution for example key reset combination to reset the controller to start working properly?
I am used it for the long time. Last time when it used, it works perfectly

Thanks a lot for your help
Pixsys tecnico 1
Moderatore
Posts: 1649
Joined: 29/10/2010, 10:09
Contact:

Re: Problem with starting ATR620 process controller

Post by Pixsys tecnico 1 »

The controller starts normally with these writings and then with the ambient temperature (on the upper display) and Stop (on the lower display). Then you have to press START/STOP button to select the cycle you want to run and then press OK. If it does't work, the controller is probably damaged.
user6743
Posts: 2
Joined: 26/09/2013, 22:43

Re: Problem with starting ATR620 process controller

Post by user6743 »

Thank you very much for you quick answer
Post Reply