Pixsys Forum

Greetings!

I have purchased 0-6 bar, 4-20mA relative pressure transmitter Pixsys 2000.40.103.

It has 4 pins.

Do I understand correctly, that I have to connect to pin1 and pin2: the power supply, the load resistance and also voltage measuring device?

And pin3 and pin4 can stay unconnected?

Thank you in advance!

Hi,
the PINS 3 and 4 are not used. How did you connect the PINs 1and 2?

Best regards.

It's like I say:

I connect power supply (+) in series to the one end of load resistor. Other end to PIN2. And power supply (-) to PIN1.
And I read voltage drop on load resistor with voltmeter.

Is it correct?

Hi,
can you post the wiring diagram of the connection you want to perform?

Best Regards.

Just simply like this:

Yes It is correct.

Best Regards.