Iris _

Pixsys Forum

everybody's effort for the same goal

ETD1644-AD with TD410

Post Reply
eeirich
Posts: 3
Joined: 07/01/2020, 9:11

ETD1644-AD with TD410

Post by eeirich »

Hallo i have a little Problem.
I would like to control a simple encoder
but do not know exactly how to use the parameters.
the following Parameters I have set:

Encoder/Counter 3 Setup Adress 2063 = 3 = Counter UP
Encoder/Counter 3H preset Value 2069 = 0

where i can see the Counter Value?

Could someone give me a tip
how to set it!

Thanks in Advance
Pixsys tecnico 6
Moderatore
Posts: 1184
Joined: 12/09/2016, 14:49

Re: ETD1644-AD with TD410

Post by Pixsys tecnico 6 »

Hi,
you can see the Counter Value by 1010 and 1009 Modbus registers value. The value is a DWRORD (16bit + 16bit) and it is splited to "Low" and "High" parts.
Advise: if you want insert a value of the encoder preset, you must use the registers number 2069 and 2070 (not only 2069).

Best regards.
Post Reply