Iris _

Pixsys Forum

everybody's effort for the same goal

movicon issue with symbol file on startup

Post Reply
JamieP4A
Posts: 4
Joined: 01/08/2019, 10:07

movicon issue with symbol file on startup

Post by JamieP4A »

All, I am currently using a TD710 HMI, when I try to run my movicon program, I am getting an error via a pop up on screen:
"Cannot validate symbol table at startup, please check symbol table path and connection to the PLC then restart"

I believe the issue is with paths in the stations settings in comm drivers, and it not auto-populating or copying the file over.

Any ideas, as this is very frustrating.
Pixsys tecnico 6
Moderatore
Posts: 1184
Joined: 12/09/2016, 14:49

Re: movicon issue with symbol file on startup

Post by Pixsys tecnico 6 »

Good morning,
in the links below follow tutorial number 4 and 5 where it shows how to correctly configure the Movicon Station and how to correctly import PLC variables.

https://forum.pixsys.net/viewtopic.php?f=25&t=1768

Best Regards.
JamieP4A
Posts: 4
Joined: 01/08/2019, 10:07

Re: movicon issue with symbol file on startup

Post by JamieP4A »

Hi Pixsys tecnico 6, When I carry out the instructions in step 5, it does not copy the sym. xml file over to the HMI, even after I have uploaded the project. thoughts?

Thanks
Jamie
Pixsys tecnico 6
Moderatore
Posts: 1184
Joined: 12/09/2016, 14:49

Re: movicon issue with symbol file on startup

Post by Pixsys tecnico 6 »

Hi,
please check the LogicLab settings.
LogicLab_symbol_enabled.PNG
Can you post the Movicon Station configuration?

Best Regards.
You do not have the required permissions to view the files attached to this post.
JamieP4A
Posts: 4
Joined: 01/08/2019, 10:07

Re: movicon issue with symbol file on startup

Post by JamieP4A »

Capture.PNG
You do not have the required permissions to view the files attached to this post.
Pixsys tecnico 6
Moderatore
Posts: 1184
Joined: 12/09/2016, 14:49

Re: movicon issue with symbol file on startup

Post by Pixsys tecnico 6 »

Hi,
please download an install the last version of the Movicon and PixsysSuite software at follow link:
1.https://cloud.pixsys.net/
Download_Mov_Log.PNG
2.Instal the last driver available:
Download_last_drivers.PNG
3. Close your Movicon Project and delete the follow files by your project RESOURCES folder.
Movicon_file_settings.PNG
4.Please check your Movicon Station settings. At follow picture there is a Typical settings:
Movicon_Station_conf.PNG
Best Regards.
You do not have the required permissions to view the files attached to this post.
Post Reply