Last visit was: It is currently 02/06/2020, 15:02


All times are UTC + 1 hour [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: ETD1644-AD with TD410
PostPosted: 22/04/2020, 8:26 

Joined: 07/01/2020, 10:11
Posts: 1
Hallo i have a little Problem.
I would like to control a simple encoder
but do not know exactly how to use the parameters.
the following Parameters I have set:

Encoder/Counter 3 Setup Adress 2063 = 3 = Counter UP
Encoder/Counter 3H preset Value 2069 = 0

where i can see the Counter Value?

Could someone give me a tip
how to set it!

Thanks in Advance


Top
Offline Profile  
 
 Post subject: Re: ETD1644-AD with TD410
PostPosted: 08/05/2020, 16:19 
Moderatore

Joined: 12/09/2016, 14:49
Posts: 777
Hi,
you can see the Counter Value by 1010 and 1009 Modbus registers value. The value is a DWRORD (16bit + 16bit) and it is splited to "Low" and "High" parts.
Advise: if you want insert a value of the encoder preset, you must use the registers number 2069 and 2070 (not only 2069).

Best regards.


Top
Offline Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC + 1 hour [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
Theme created StylerBB.net & kodeki