Last visit was: It is currently 22/01/2020, 21:40


All times are UTC + 1 hour [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: [ATR243-20ABC] 0-10v output configuration
PostPosted: 17/04/2013, 16:58 

Joined: 17/04/2013, 16:47
Posts: 2
Hi,
I have set up a ATR243-20ABC for the following:
PT100 input. SEn = Pt1
0-10v output terminals 4 & 5. C.out = c.0.10
JP5 inserted
JP7 inserted
JP9 inserted for linear output in Volts

The problem is I am only getting an output of either 0v or 10v.

Can anyone suggest where I may be going wrong?


Top
Offline Profile  
 
 Post subject: Re: 0-10v output configuration for ATR243-20ABC
PostPosted: 17/04/2013, 17:16 
Moderatore

Joined: 29/10/2010, 10:09
Posts: 1311
Hi,
to have the linear output fully working you must use the regulator in PID mode. To do this the easiest way is to run an auto-tuning cycle so the controller calculates itself parameters 18, 19, 20 (Proportional band, Integral time, derivative time), see par. 7.2 ... 7.4 for further informations.


Top
Offline Profile  
 
 Post subject: Re: 0-10v output configuration for ATR243-20ABC
PostPosted: 17/04/2013, 17:49 

Joined: 17/04/2013, 16:47
Posts: 2
Many thanks for your help. All working ok after running auto-tune.

Regards,

Ian


Top
Offline Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC + 1 hour [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
Theme created StylerBB.net & kodeki