Iris _

Pixsys Forum

everybody's effort for the same goal

atr 236 -SOFT START gradient

Post Reply
aljazr
Posts: 1
Joined: 21/05/2020, 10:36

atr 236 -SOFT START gradient

Post by aljazr »

Hello,

I'm trying to program this controler with gradient function but i simply cant do it. I program parameter GRAD to 60.0 which is degrees of celsious per hour - so says the manual. If i make 60.0 i suppose it should rise with gradient 1 degrees Celsious per minute.

What am I missing here?? Because when I set GRAD parameter to 60, leave parameter site and set temp to 100° C controller give 100% output for heateer and gradient is much faster.

Which parameter should be set correcty that grad funcion is turned on?
Pixsys tecnico 6
Moderatore
Posts: 1184
Joined: 12/09/2016, 14:49

Re: atr 236 -SOFT START gradient

Post by Pixsys tecnico 6 »

Hi aljazr,
please can you post the ATR236 parameters list?

Best regards.
Post Reply