[TCT101-2ABC] Wrong value reading
Posted: 27/04/2015, 15:01
Hello,
I am using TCT101-2ABC + Wire draw encoder
A and B output of encoder is connected to Pixsys A and B input
Problem:
when wire is pulled out it shows correct value but when it gets a bit moved or shaked, there appears ~1-3 mm error from correct value
Encoder output is 1imp/0.5mm
This can happen (as I am told by client) at any lenght (1m , 3m ...)
Could it be that output of encoder is being in position in which it fluctuates (output is switching on/off)?
Z at the moment is not connected, if I connect can it help?
I am using TCT101-2ABC + Wire draw encoder
A and B output of encoder is connected to Pixsys A and B input
Problem:
when wire is pulled out it shows correct value but when it gets a bit moved or shaked, there appears ~1-3 mm error from correct value
Encoder output is 1imp/0.5mm
This can happen (as I am told by client) at any lenght (1m , 3m ...)
Could it be that output of encoder is being in position in which it fluctuates (output is switching on/off)?
Z at the moment is not connected, if I connect can it help?